Back

FS SYSTEM

A DUAL FUNCTION FREESTANDING & SNAP ON STRINGER SYSTEM

& A DUAL FUNCTION BOLT ON STRINGER & SCREW DOWN SYSTEM

The FS access floor panels are structurally rigid linear assemblies fabricated from non-combustible components and consists of high hardness top steel sheet, welded to a deep drawing steel bottom section of domed formation. The underside of the panel shall consist of a specially designed four corner self-locating and solid locking system. It has a 18 convex salient point structure and an international dome design.

 

All these additional design features result in the higher dimensional precision and panel strength.  The exterior and interior surface of the panel is corrosion protected. The core of the panel is filled with a non-combustible cementitious compound. The exterior of the panel is epoxy coated.

 

The Under-Structure System

The FS Under-Structure System is generic to the Freestanding System and the Snap-on Stringer System. The understructure is universal to all 3 grades of floors, ranging from standard to heavy duty floors. The system consists of an aluminium die cast, factory assembled head and steel base which is surface treated with a corrosion-resistant finish. This assembly is capable of supporting a minimum load of 22.5kN. The Under structure must comply with CISCA Section 5 of 2007 test procedures for Pedestal Axial load.

 

A corrosion resistant lock nut with an anti-rotation & vibration proof feature is provided to allow the

pedestal assembly to be adjusted over a range of 50mm (25mm up and 25mm down).

Download

Spec Sheet

www.supertecceilings.co.za

© 2018 Supertec Ceilings & Board (Pty) Ltd

Site Designed by AREMEDIA